Morini CM162 Front Sight

I couldn't get a new front sight for my Morini CM162e air pistol anywhere so I measured it up and did it myself. I measured it off the "old version" with 1x15v battery but I'm sure it would fit any Morini CM162 (electronic or manual). This is the 3rd version as I finetuned the measurements to make it a direct replacement. I had to change tiny things like the screw hole being a fraction tight or the height being slightly off.

I'm currently using one of the on my Morini (4.5mm wide I think I printed for myself) and I didn't even have to adjust the rear sight!

I've used ring sizes to represent the sight width. Height is approx 7mm - pretty much the same as the original factory sight.

3/44 is 3mm wide
3.5 / 45.25  is 3.5mm wide
4/46.5 is 4mm wide
4.5 / 47.75  is 4.5mm wide
5/49 is 5mm wide
5.5 / 50.25 is 5.5mm wide
6 / 51.5 is 6mm wide

10 / 61.5 is 5mm wide but about 2mm taller than all of the other versions.
10.25 /62.125 is 3mm wide and approx 1mm taller than my originals
10.5 /62.75 is 3.5mm wide and approx  1mm taller than my originals
12 / 66.5 is 4.5mm wide and approx 1.4mm taller

Please check the height (the model will tell you the total height) - I've had a few people order and my sight has been shorter than their stock ones. I can customize to any height, so it is not a problem, but better to check first. If worried, perhaps print 1 in plastic before doing it in metal. I'll lower my markup on plastic versions to make this more attractive.