BMH Anakin EP2 "Council" Chassis (NPXL v2)

This is a "Council" (no Masters here) chassis designed to fit the BMH Anakin EP2 hilt. This chassis is our highest tier design, the main body is printed in SLS Nylon with the accent pieces printed in Brass with optional plating.

Guidebook Here

Parts

• Main Body - SLS Nylon
• Switch Chassis - SLS Nylon (printed attached to inside of battery slot)

Supported Components

• Proffie v2.2 or GHv3
• 18650 Protected Button Top Battery w/ Keystone Contacts
• 22mm KR Sabers Bass Speaker
• TCSS OLED or Accent Neopixel Strip
• SCW or CCSabers Neopixel Connector
• 3mm standard accent LEDs

 

Assembly
Use wire snippers or an x-acto knife to cut the supports from the sides of the switch chassis. This will free the switch chassis and plungers from the main body. Then trim off the support material to free the plungers. The plungers slide into the switch body and should be able to move freely along the guides. You may need to clean loose powder from the switch chassis holes before inserting the plungers. 

The switch chassis is designed to fit into the clamp section of the hilt and the plungers push tactile switches installed on the back side of the main chassis body.