You must be logged in and verified to contact the designer.
Product Description
This is a "Council" (no Masters here) chassis designed to fit the Watto's Junkyard Tusken Slayer (v1 or v2) hilt. This chassis is our highest tier design, the main body is printed in SLS Nylon with the accent pieces printed in Brass with optional plating.
Switch Chassis - SLS Nylon (printed attached to inside of battery slot)
Supported Components
Proffie v2.2 or GHv3
18650 Protected Button Top Battery w/ Keystone Contacts
22mm KR Sabers Bass Speaker
TCSS OLED or Accent Neopixel Strip
SCW or CCSabers Neopixel Connector
3mm standard accent LEDs
Assembly Use wire snippers or an x-acto knife to cut the supports from the sides of the switch chassis. This will free the switch chassis and plungers from the main body. Then trim off the support material to free the plungers. The plungers slide into the switch body and should be able to move freely along the guides. You may need to clean loose powder from the switch chassis holes before inserting the plungers. If the plungers are tight, try spinning a drill bit by hand in the holes to clear out any burrs or loose material.
The switch chassis is designed to fit into the clamp section of the hilt and the plungers push tactile switches installed on the back side of the main chassis body.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: