Jurassic World Badge Part 1: Add your own name

Here are the main parts for the Jurassic World Badge Kit. The back section to complete your badge is here 

To customize your nametag, contact me before purchasing and we can discuss your design. All parts will require painting so use the photos above of the screen used badge I obtained as a painting reference.

 

On offer here is my replica of the badge worn by all Employee's in Jurassic World. These were mainly seen in the montage of the park in action and during the Aviary breakout. A friend of mine who was in the movie and owns the prop has scrutinized my model and has confirmed mine is accurate in scale and detail.

 

The badge measures roughly 6.8cm in width and 5cm in height and has recesses in the back for you to add 10mm Neodymium Magnets (earth magnets) You can purchase them here . To wear your badge just place it on your garment and pop the magnets inside. If you prefer to use velcro or a pin that is entirely up to you. Just have fun with it :)

 

This model is licenced under a Creative Commons non Commercial license

Any reproduction of this piece once purchased is forbidden I have left telltale signs on the model so I can recognise it instantly.

 

Thanks for looking :)