Crystal Chamber--1.00 inch--Spinning--Part 03

Print With Shapeways

Choose Your Material

$10.00

Versatile Plastic
Starting at $ 14.00

Fine Detail Plastic
Starting at $ 10.00

Choose your color and finish

You must be logged in and verified to contact the designer.

This contains two parts: the spindle mount and the led holder.
Spindle Mount: This is the spindle mount for the motor. It fits inside the bottom of part 03. If it is not a friction fit, glue it. You will need to clean printing powder out of the center hole. If you use a different motor, drill out the spindle mount to fit the new motor spindle. If the spindle is not a tight fit, glue it.

LED Holder: This part fits inside part 02 and holds a 3mm acent led. It is recommended to sand the led to be flat instead of round.
Recommended smallest motor: https://www.ebay.ca/itm/Smallest-Electric-DC-Motor-Very-Small-Miniature-Tiny-Mini-hobby-drone-plane/171185241052?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

Recommended bearing: https://www.bearingscanada.com/10-Bearing-6700-2RS-10x15x4-Sealed-Ball-Bearings-p/10-6700-2rs-10x15x4-sealed.htm