SCLPT26 Body

SCLPT26 squonker

This is a 26650 semi mechanical squonker mod, compatible with Switchfet v2 from Infiniohm (available at Modmaker), MM 26650 tube, MM510 Squonker connector (v1 and v2 will work fine), and MM Squonker bottle. The hole for the bottle is slightly less than 18mm in diameter.

RDA compatibility

The cutout for RDA is compatible with 24 mm or smaller RDAs, at the highest point the RDA cutout is 6mm high, 3mm high at the lowest, this can be reduced if you use the MM510 washer which will add 1mm to RDA height. Hadaly, Wasp Nano, Gorge are all ok - airflow is not obstructed, but you might have a problem with a 24mm RDA that has bottom airflow.

In order to make the SCLPT26 squonker mod, you will need:
3d printable parts, available here:

• SCLPT26 Body (you are here)
• SCLPT26 Switch
• SCLPT26 Switch Frame
• SCLPT26 Underbottle cap

Also you'll need to purchase other components, which are:

• MM510 Squonker Connector
• MM510 24mm or a smaller washer (this one is optional - there is a recess in the body to neatly fit the 510 without a washer)
• MM 26650 Battery Tube, either brass or SS
• MM Round squonker bottle
• Switchfet v2
• Wiring as per modmaker diagrams to solder the Switchfet v2, as required.
• 3 neodymium block magnets for the Switch frame to hold it in place on the body - magnet size 6x2x2mm. Magnets going into the body of the mod, and into the switchframe have to atract each other, the third one going into the switch must repel the one in the switchframe. 

510, battery tube and Switchfet are available from modmaker.co.uk
magnets are available from skymagnets.com

This device is for advanced vapers and medium to advanced DYI'ers, as it requires soldering, and generally you have to know what you are doing when you are soldering, and subsequently vaping it. Proceed at your own risk.