dsynmunky Cool thanks for the picks but you would still have to send me the part if you want it built. As I mentioned before I have to take calipers to it to get the 1/10mm accuracy.
dsynmunky @dbarbary79I believe I have an earlier set of the curtain than you do because I don't seem to have that part. could you take a photo of the pin for me from a couple of angles so I can see what I looks like. Also you would have to mail me the pin so I can measure it to be able to build it. I has to be accurate to .1mm tolerances.
dsynmunky Yes it is, if you need the "panel catchers" you can find them on the IKEA website:
http://www.ikea.com/us/en/catalog/products/80299157/
I would double check if this newer curtain panel holder works with the curtain rail you have at your place. I would buy it at IKEA and return it if doesn't fit. No I don't sell the rod , it would be very expensive plus Shapeways can't print anything that long.
dsynmunky@brandieryan1109
Any hardware store should carry a wide variety of screws. Just take one of the other screws from your curtains with you to the hardware store so the can match it.