Prototypes has already been printed
I now offer you the optimized versions!
The Phantom 2 Shell Bottom CoverWith this Shell Bottom Cover for the Phantom 2 chassis The
you can close the opening in the bottom of a Phantom 2.
Anyway it´s possible to work on the material with a sharp knife (cutter / carpet knife)
to edit it for something like a cable lead-through.
The Phantom 2 Shell Antenna
This part may be usefull, for example, to lead an antenna directly out through the hole under the receiver in a phantom 2 chassis.
Particularly interesting for those who move their Phantom1 in a Phantom2 chassis.
Or even if you have installed a different landing gear here.
But perhaps it is even interessting for Phantom 2 owner
because it should still be possible to push the connecting Button of the receiver wich is situated at this position at a Phantom 2 .
By order the part in transparent material you should still be able to see the Status LED!
The Buttons
This are simple buttons that you can implement in different places.
The two workpieces can easily be cut on the bridge between them and then be used seperate.
Despite the quit tough Material,
the height of the buttons is editable relatively well with a sharp knife (cutter / carpet knife).
So they can be adapted to many situations.
One side of the Buttons has a diameter of 1.8mm (0.07 in)
the other side has a diameter of 3.7mm (0.145 in)
Both sides of the workpieces have a height of 3.5 mm (0.138 in)
Here is a report about my own conversion. (in German)
HAVE FUN!!!
I take NO RESPONSIBILITY for any kind of defect or damage that would occur due to this change!
Prototypen wurden bereits gedruckt
die optimierten Versionen biete ich nun euch an!
Das Phantom 2 Shell Bottom Cover
Mit dieser Abdeckung könnt Ihr die Öffnung im Boden eines Phantom 2 Chassis verschliessen.
Das Material lässt sich trotzdem noch mit einem scharfen Messer (Cutter/Teppichmesser) bearbeiten
um evtl. Kabeldurchführungen oder ähnliches zu ermöglichen.
Die Phantom 2 Shell Antenna
Mit diesem Teil kann man z.B. eine Antenne direkt durch das Loch unter dem Empfänger in einem Phantom 2 Chassis herausführen.
Interessant vor allem für diejenigen, die Ihr Phantom1 in einen Phantom2 Chassis umziehen.
Oder auch wenn man hier ein anderes Fahrgestell installiert hat.
Aber evtl. ist es sogar für Phantom 2 Besitzer nützlich,
da die Bedienung des bei dem Phantom 2 Empfänger an dieser Stelle sitzenden Kopplungsknopfes erhalten bleibt
und bei Bestellung des Teils in Transparentem Material ist auch die Led des Empfängers zu sehen!
Die Buttons
Dies hier sind ganz einfach Knöpfe, die man an verschiedenen Stellen einbauen kann.
Die beiden Rohlinge können an dem Steg auch einfach geteilt werden.
Die Höhe der Knöpfe ist trotz des sonst robusten Kunsstoff noch relativ gut mit einem scharfen Messer (Cutter / Teppichmesser) zu bearbeiten.
So können Sie auf viele Situationen angepasst werden.
Eine Seite der Knöpfe hat einen Durchmesser von 1,8mm
die andere Seite hat einen Durchmesser von 3,7mm
Beide Seiten des Rohlings haben eine Höhe von 3,5mm
Hier eine Bericht über meinen Umbau.
VIEL SPAß!!!
Ich übernehme KEINE VERANTWORTUNG für jede Art von Defekt oder Beschädigung
die durch diese Veränderung eintreten sollte!