New to 3D printing. I have a Fusion 360 file and a solidworks file for the part I want to print, but the print service folks here at shapeways can't take that file format and the software blocks me from uploading to this thread. I've attached a png file. Can anyone help me to convert it to STL so I can get a quote? Looking to print one prototype and then a plate full (up to 100 pcs). Ideally, I'd like to modify the design slightly by extending the cylindrical section. The original is poorly designed and is the single point of failure on every assembly I've ever seen. Extending the cylinder to reinforce the left wing will slightly reduce travel for the threaded part, but should greatly enhance part life. I'd like these printed with black nylon, aluminum or stainless steel depending on capability and cost. Part is about 5mm x 2.5mm x 4mm in max dims.
Did you create the part in Fusion360? If so follow this link on how to save as a STL. https://knowledge.autodesk.com/supp...ow-to-export-an-STL-file-from-Fusion-360.html